Ford expedition engine cutting off while driving. If you are driving a 2003 ford expedition or if you are planning to purchase one then it is important that you review reported fuel propulsion system problems and defects.
My fuse panel has an intermittent operating fuel pump relay that has begun melting the outer case.
You can find out more Diagram below
2003 expedition fuse box problem. 2003 ford expedition electrical system problems defects. Ts nar the vehicle stalled while being driven. Tried 102 and 101 fuses.
I replace the fuse box for another used one that i bought at a junk yardthe truck run got for a year on 01052016 it happen again while driving the truck on the 118 fwy going 75 the truck shut off again same problem fuse box fuse relay is burn in have post it 3 videos on you tube look for 2003 ford expedition xlt 46 cranks wont start is. Average repair cost is 370 at 119750 miles. 2003 ford expedition wont start.
The most recently reported issues are listed below. I have finally fixed my stalling problem in my 2003 ford expedition and wanted to share the repair. Also please check out the statistics and reliability analysis of ford expedition based on all problems reported for the expedition.
The 2003 ford expedition has 7 problems reported for fuse circuit board shorted out. The problem was diagnosed as a relay problem and replaced the relay. Buzzing fuse box happened before.
Was driving the 2003 expedition on interstate 10 near pensacola when the vehicle shut off. These sites mentioned in the above post were extremely helpful to diagnose the problem. Ford expedition owners have reported 21 problems related to fuses and circuit breaker under the electrical system category.
I checked my fuse box and i did have dripping water in it along with corroded connectors inside the vehicle. 2003 expedition relay junction box burned. When it happened before rotated 6 big relays and it started ran fine for a year.
Just now doing same thing tried the relays again didnt work this time. I replaced the fuse box and saved me because i did the work.
0 comments:
Post a Comment